Pipe clamp installation method:
Assembly in the welding plate before assembly, in order to better determine the direction of the clip, it is recommended to do a good job in the fixed mark, after welding welding, embedded in the lower part of the tube clip, put a fixed tube. And then put the other half of the tube clip and cover, with screws tightened. Do not weld directly to the bottom plate that has been fitted with a clamp.
Mounted rails, rails can be welded on the basis of, or fixed with screws, and then push the rail nut into the rail, and turn 90 degrees, the second half of the tube clip into the nut, put the tube to be fixed, On the upper half of the pipe clip and cover, with screws.
Stacking assembly, rails can be welded on the basis of, or fixed with screws, first installed on the second tube clip body, put on the tube to be fixed and then put the upper half of the tube clip, fixed with screws, Prevent it from turning. Then install the second clamp, the same as above.
Bend the assembly, the installation of elbow, should be directly in the front and rear of the elbow with Yongsheng tube clamp fixed. It is recommended that such a support point should be a fixed position.
